the main dealer.

On earlier models like the X1, and early X1.1 and X4, there is typically only one screw at the top.Once opened, you will often find the old seal has disintegrated.

The new foam seal sits neatly around the circular opening inside, and is held in place once the internal section is twisted back into position.. Not Sure Which Seal You Need?.If you are unsure whether it is the.foam inlet seal.

or the visible rubber one (called the.lower body seal. )

that needs replacing, it may be sensible to order both.

They are inexpensive, and it avoids the inconvenience of placing a second order later.. As we charge a flat delivery fee regardless of the size of your order, and these are very small parts, it is also a good time to stock up on any bags, filters, service boxes or accessories you might need.You switch the machine on and nothing at all happens.

Out of the blue.No warning lights.

No smoke, bad smells or rumbling – just silence.. As long as there were no warning signs to herald its demise, the most likely cause is the power cable.Even if there’s no visual damage, wear and tear can cause the cable to fail internally close to where it goes into the machine.